Sodium-Ion Battery — Telecom & Starter Solutions

Sodium-ion (Na-ion) is a chemistry we offer alongside LiFePO4 where temperature or shipping drives the design. It keeps more usable capacity in deep cold, discharges without a heater, and a cell can be shipped at 0 V. For sites and vehicles where winter is the constraint, that changes the maths. We manufacture both and will tell you which fits.

Built in XGW’s own Shenzhen and Zhongshan factories, every sodium-ion pack uses rated sodium cells with a protected BMS (RS485/CAN) and full UN38.3 transport documentation — the same build discipline behind our LiFePO4 lines, and why we have supplied battery systems to 50+ countries since 2009.

Two Sodium-Ion Products

48V Sodium-Ion Telecom Battery

50 / 100 / 200 Ah · 2.4–9.6 kWh · 19-inch rack

  • Discharge to -20℃ with no heater (cells rated -35℃)
  • 4,000 cycles to 80% SOH (25℃, 0.5C/0.5C)
  • RS485 + CAN BMS, LCD, Bluetooth, SNMP gateway on request
  • UN38.3; ships in UN carton / wooden box

48V Sodium-Ion Telecom Battery →

12V & 24V Sodium-Ion Starter Battery

12V 50Ah · 24V 100Ah · IP65

  • Cranks to -40℃ without pre-heating (800/1000 A peak)
  • >6,000 cycles @ 80% DOD; ≥100,000 start-stop cycles
  • Ships and stores at 0 V — simpler air/sea freight
  • JIS and DIN footprints; UN38.3, cells to UL1642 / IEC62133-2

12V / 24V Sodium-Ion Starter Battery →

Datasheets & Documents

Specification sheets and technical references for the XGW sodium-ion range. Model datasheets are matched to the product families above; the manual and cycle-life report apply across the range.

Not sure which chemistry fits? The LiFePO4 48V telecom pack and the sodium-ion range are both built by XGW — tell us your site temperature and duty cycle and we will specify.

Why Sodium-Ion, and When

Sodium is not a straight upgrade over lithium — it trades energy density for temperature behaviour and shipping simplicity. The table below is how we frame the choice with operators and fleet buyers.

AttributeSodium-IonLiFePO4Lead-acid
Cold dischargeFull at -20℃, no heaterReduced; heater draws powerSevere loss
Cycle life4,000–6,000 cycles6,000+ cycles300–500
Energy density~80 Wh/kg (pack)Higher (~150 Wh/kg)Low
Shipping / storageShips at 0 VState-of-charge limitedLeak / sulphation risk
Best forCold / remote sites, cyclic start dutyTropical / general, dense packsLegacy only

Pick sodium-ion when winter capacity or heater power draw drives your design. For temperate, density-sensitive systems, the LiFePO4 48V telecom pack gives more kWh per kilo. Both are in the Battery & ESS hub.

Typical Applications

Cold-climate BTS

Unheated cabinets and alpine sites where heater power or maintenance is the constraint.

Off-grid solar BTS

Deep daily cycling in unheated enclosures.

Vehicle starting

Cars, motorcycles, trucks, construction equipment and marine — reliable cold starts.

Seasonal equipment

Gensets and backup plant that sit for months, then must start.

Spare-unit fleets

Held at storage voltage, commissioned when a site needs them.

Frequently Asked Questions

When should I choose sodium-ion over LiFePO4?

When winter performance and lifecycle cost drive the design. If your sites see months of sub-zero temperatures and you are budgeting heater energy, heater maintenance or winter capacity derating, sodium-ion is worth evaluating. If the site is temperate and you are optimising for cycle life and energy density, our LiFePO4 range is the better fit — we make both and will say so either way.

Is sodium-ion safe to ship?

A sodium-ion cell can be discharged to 0 V for transport, which removes the state-of-charge limits that apply to lithium in air and sea freight. UN38.3 test documentation is still required — we provide it with the shipment.

Can a sodium-ion starter battery replace lead-acid directly?

In most 12 V and 24 V systems yes, provided the charging system's voltage window is compatible. Sodium-ion has a different voltage curve from lead-acid, so we recommend checking the alternator regulator set-points with us before a fleet-wide swap. We supply the charging profile for your platform.

Why XGW

Need a Sodium-Ion Battery?

37 senior R&D engineers. OEM/ODM — desarrollo personalizado y de proyectos bienvenido; volumen estándar desde 500 unidades. Samples in 3-7 days.

Get a Quote WhatsApp