LED Driver Dimming Methods: 0-10V, DALI, PWM, TRIAC

LED DriverDimmingControls

Dimming an LED is not like dimming a bulb. The driver must understand the control method, and constant-current fixtures need a dimming scheme that keeps current stable to avoid flicker.

0-10V (Analog)

A low-voltage control wire sets brightness 100%-10%. Simple, cheap, one-way. The workhorse of commercial retrofits.

PWM (Pulse Width)

The driver chops the current rapidly to vary average brightness. Efficient and deep-dimming, but needs clean implementation to avoid visible flicker.

DALI-2 / D4i (Digital)

Addressable, two-way, standardized. D4i adds self-describing drivers and sensors on the bus. Best for networked, tunable sites.

TRIAC / Phase-Cut

Mains phase dimming for retrofit with legacy wall dimmers. Hardest to do flicker-free on LEDs; pick a driver explicitly rated for it.

Avoiding Flicker

Match the control method to the driver, set a sensible minimum dim level, and use a constant-current driver spec'd for the method. See the constant-current vs constant-voltage guide.

Can I use a 0-10V driver with a DALI system?

Not directly; you need a DALI-to-0-10V gateway or a native DALI-2 driver.

Why does my LED flicker when dimmed?

Usually a mismatch between dimmer and driver, or a driver hitting its minimum-current floor. Use a rated pair and raise the min level.

Related Products

More Reading

Need a Custom Power Solution?

37 senior R&D engineers. OEM/ODM from 500 units. Samples in 3-7 days.

Get a Quote WhatsApp Us