The EU compliance baseline
A power supply placed on the EU market must meet the Low Voltage Directive (2014/35/EU) and EMC Directive (2014/30/EU), with safety evaluated to EN 62368-1 and EN 61558 depending on class. RoHS and REACH restrict substances; the ErP Lot 9 rules push external supplies toward higher active-mode efficiency. XGW units are built to EN 62368-1 with CE, CB, RoHS and UKCA marking and the supporting Declaration of Conformity.
DIN-rail is the European default
Nearly every EU control cabinet uses TS-35 DIN-rail mounting. The practical spec: 24V or 48V output, adjustable ±10%, overload and short-circuit protection, and low inrush so several units on one breaker don't trip at power-on. XGW's DIN-rail range runs 35W–480W for this exact use.
EMC and the cabinet
A supply with CE EMC marking is necessary but not sufficient — the cabinet layout, grounding and cable routing decide whether the machine passes the notified-body test. Keep the supply away from sensitive analog loops, use shielded output runs where required, and document the supply's emission/immunity levels in the technical file.
Efficiency and ErP
For enclosed and adapter supplies, active-mode efficiency and no-load power draw are now gated by ErP. Spec a unit whose efficiency curve matches your typical load point, not just the peak — most cabinets run their supply well below nameplate, where cheaper designs waste the most.
Custom AC-DC for OEM machinery
Machine OEMs often need a specific voltage, connector or form factor. XGW's custom AC-DC service matches the enclosure, with CB-scheme safety data that drops straight into your EU technical file.
Lead time and MOQ
Standard units ship in 7–15 days, samples in 3–7 days, custom in 25–35 days. OEM/ODM volume on standard lines starts at 500 units; project development is welcomed at lower volumes with no fixed MOQ.
Frequently Asked Questions
What EU directives apply to a 24V DIN-rail supply?
The Low Voltage Directive and EMC Directive, with safety to EN 62368-1 (and EN 61558 for some classes), plus RoHS/REACH substance limits and ErP efficiency for external units.
Does CE marking mean it will pass my machine's EMC test?
CE EMC marking on the supply is necessary but not sufficient — cabinet layout, grounding and cabling decide the final result. Use the supply's emission/immunity data in your technical file.
Can you supply a custom voltage or form factor for OEM machinery?
Yes, the custom AC-DC service matches voltage, connector and enclosure, with CB-scheme safety data for your EU documentation.
What is the European MOQ and lead time?
Standard-line OEM/ODM from 500 units; samples 3–7 days, standard 7–15 days, custom 25–35 days. Lower-volume project work accepted.
